Sewage coming up a basement drain means stop using water
If the floor drain, a basement toilet or the basement shower is backing up, the water you use upstairs has nowhere else to go. Every flush, load of laundry and dishwasher cycle adds to what comes up. Stop all of it, and tell everyone in the house.
Keep people and pets off the wet floor, because it is sewage. If the water is near an outlet, the furnace or the water heater, stand somewhere dry and turn off the breaker for that area. Then call it in as an emergency. The blockage is somewhere between that drain and your septic tank, and the first job is finding where.
Slow drains through the whole house point to the line or the tank
One slow sink is a local clog. Several slow fixtures at once, toilets gurgling when the tub drains, or the lowest drain backing up all point to the building drain or the pipe out to the septic tank.
Then work out whether it is the pipe or the tank. Think back to when the tank was last pumped. If it is overdue, or the ground over the leaching bed is wet and smells, the tank or the bed may be at fault, and the tank gets pumped before any pipe work. If it was pumped recently and the house still backs up, the pipe is blocked. Questions about septic system inspections go to the Township of South Frontenac.
Check the yard too. A wet, sunken or smelly patch along the route from the house to the tank usually means a cracked or separated pipe leaking into the soil.
Each age of house fails in its own place
In the 1860s to 1900 houses on George Street and Mill Street, the drain usually leaves the house through a cast-iron stack and runs out to the tank in clay tile. Roots get into the clay joints, and old tile cracks. If roots come back a few months after clearing, the problem is the tile itself.
Houses built from 1961 to 1980 usually drain through cast iron or ABS plastic to a tank and leaching bed. Cast iron rusts and cracks with age. Many septic systems put in with these houses are at the end of their life, so in these houses it is especially important to settle whether the pipe or the tank is at fault before paying for work.
Newer houses on Rutledge Road and Stage Coach Road drain through PVC or ABS. That pipe rarely fails on its own. When it does, the usual cause is a joint that has pulled apart or a section that has settled and holds water.
A camera inspection shows the fault before anything is dug
The camera goes in through the cleanout and is run down the line toward the tank. It shows roots, cracks, offset joints, low spots that hold water and the point where one pipe material changes to another. Ask to see the footage.
The camera head carries a transmitter. Standing in the yard, the technician follows its signal and marks where the fault is and how deep the pipe runs at that spot. The repair is priced from that mark.
You get a written price before any work starts. If clearing the line will hold, that is the whole job. If the pipe is broken, you get the repair price in writing and decide. The guide on how a plumber prices a job explains how that number is put together.
Digging starts with a locate, and your own line is not on it
In Ontario, a locate must be requested before any digging, through Ontario Dig Authority (formerly Ontario One Call). The locate marks buried public lines such as gas, hydro and communication cables. It does not mark private lines, and the pipe from your house to your septic tank is private. The camera mark is how that pipe gets found.
The repair depends on the fault. If roots are in pipe that is still sound, they are cut out and the line goes back under the camera to check it is clear. A cracked, root-filled or collapsed section is dug out and replaced, and the new pipe is joined to sound pipe on each side. If the whole run from the house to the tank inlet is failing, replacing it can make more sense than clearing it every year.
Plumbing in Ontario falls under Part 7 of the Building Code, Ontario Regulation 163/24. Changes to drains generally need a building permit, and the township building department will tell you whether yours does. Work is performed by licensed plumbers (306A Certificate of Qualification).
Backwater valves are for houses on a city sewer, not a septic tank
A backwater valve stops sewage in a public sewer from flowing back into a basement. The Township of South Frontenac does not own or operate sanitary sewers, so there is no city sewer under Sydenham's streets, and a Sydenham house on septic does not need one. The township's stormwater pipes in Sydenham, Harrowsmith, Inverary, Perth Road and Battersea carry rain and meltwater only, and nothing from inside the house. Our guide on what drains where explains the difference.
Kingston is different. Ontario's Building Code (Part 7, Article 7.4.6.4.) requires a backwater valve in new construction where fixtures sit below the level of the street outside, or below the upstream manhole cover in a house on a public sanitary sewer. Utilities Kingston has offered rebates when a backwater valve and a sump pump are installed together. If you live in Kingston, read the conditions on the Kingston page before you book.
To install a valve, the basement floor is opened where the building drain leaves the house and the valve is set into the line under an access cover. Open that cover and clean the valve each spring.
