A spreading leak needs the shut-off closed first
If water is coming through a ceiling, running down a wall or pooling under a pipe, close the main shut-off. In a village house on municipal water it sits where the water line comes through the basement wall, near the meter. Turn it clockwise until it stops, then open the lowest cold tap in the house to drain what is left in the lines.
If the main valve will not move, do not lean on it with a wrench. Valves that have sat untouched for decades seize, and a forced handle can snap the stem and make the leak worse. Close the small valve under the nearest sink or toilet instead, and call it in as an emergency.
In Harrowsmith, Inverary, Perth Road and Battersea the water comes from a private well. Switch off the breaker for the well pump as well as closing the valve, or the pump keeps pushing water to the leak. If water is near an outlet or a light fitting, switch off that breaker too and stay clear.
Outdoor taps and pipes in cold spaces split over winter
Raw water drawn from Sydenham Lake has been as cold as 1 degree Celsius in the winter months. Water arriving that close to freezing does not need much of a cold snap to freeze in a crawl space, a garage wall or the short run behind an outdoor tap.
An outdoor tap often splits inside the wall, where you cannot see it. The tap works in the fall, then in spring it runs outside and drips indoors at the same time. The first time you use it after winter, have someone look at the basement side of that wall.
The repair is to cut out the split section and fit a frost-proof tap, sloped so it drains when you close it. Where a supply line runs through an unheated space, we look at moving it inside the heated part of the house so the same spot does not need patching every year. Before the next freeze, close the inside valve for each outdoor tap and leave the outside tap open.
Pinhole leaks in older copper tend to come back
The 2021 census counts 21,240 of the 69,985 occupied homes in the Frontenac census division as built from 1961 to 1980. Houses of that age usually have copper water lines, and after this long the pipe wall thins. The first sign is a green crust or a damp spot on a horizontal run, often near a joint.
One pinhole can be cut out and the pipe joined again. A second one on the same stretch means the wall is thin along the run, and patching becomes a habit. We look at the pipe either side of the leak and give you two prices, one for the patch and one for replacing that section, and you decide.
The same houses often still have their original shut-offs and fixtures. Turn each valve under the sinks and toilets once a year. If one will not turn or weeps at the stem when it does, have it replaced while the water is already off for another job.
Galvanized, lead and older plastic pipe is replaced, not patched
The frame houses on George Street and Mill Street date from the 1860s to about 1900. Ontario houses of that age typically have galvanized steel water lines, which rust from the inside until the flow drops to a trickle. Low flow upstairs, brown water after the tap has sat, or a leak at a threaded joint all point to the pipe itself. Rust cannot be cleared out of galvanized line, so the fix is to replace the run, starting with the worst section.
Before booking a repair for low pressure, check whether it is only your house. If the neighbours have it too, or the water is cloudy or discoloured at every tap, the township directs pressure, quality and supply problems on the village water to Utilities Kingston.
A dull grey pipe that scratches shiny with a key and does not hold a magnet may be lead. Ontario's drinking water standard for lead is 0.010 milligrams per litre. Lead pipe is replaced, not repaired. Older plastic water pipe with brass fittings is handled the same way: the fittings corrode from inside, so we replace the line rather than the one joint that failed.
Running toilets and dripping taps load the septic system
Every drain in a Sydenham house runs to its own septic tank and leaching bed. A toilet that runs all night sends that water through the tank and into the bed, which has to absorb it. To check, put a few drops of food colouring in the toilet tank and wait. If colour shows in the bowl without a flush, the flapper or fill valve is leaking. Both are short repairs.
A toilet that rocks, or water at its base after a flush, means the wax seal under it has failed. Stop using it, because water leaking there soaks the subfloor before you see it.
Village water is marginally hard, at an average of 134 mg/l. Over time that leaves white scale on aerators and wears out tap cartridges. If a tap has lost flow, unscrew the aerator and clean it first. If a tap drips after the aerator is clean, the cartridge or washer needs replacing. We match the part to the tap where we can, rather than replacing the whole fixture.
How a repair visit works
We ask what is leaking or not working, where, and since when. On site we find the shut-off, look at the fault and the pipe either side of it, and tell you what we found. You get a written price and approve it before any part is fitted. Where a patch and a replacement both make sense, you see both numbers. How that price is put together is set out in how a plumber prices a job.
Plumbing in Ontario is governed by Part 7 of the Building Code, Ontario Regulation 163/24. Replacing a washer or a toilet part needs no paperwork. New plumbing, or a material change to the water lines or drains, generally needs a building permit, and the township's building department says whether your job does. We tell you before we start if yours might.
Work is performed by licensed plumbers (306A Certificate of Qualification). If the repair turns out to be a blocked line rather than a leak, see drain cleaning. For a tank that leaks at the base or has no hot water, see water heaters. To book, use the quote form.
